Schimb matriță de etanșare laterală a unui pahar de hârtie ZBJ-X12

Schimb matriță de etanșare laterală a unui pahar de hârtie ZBJ-X12

Video pe youtube , WhatsApp +86 15355919299 feenot8@gmail.com www.feenot.com
While user want to add extra whole set mold, (cup bottom different, or angle different)
Because cup machine already in customer factory,
This cup mold need to assemble and match the machine,
So the work should be done by customer,

Mark position, Drill, şurub, etc..
Steps:

• 1, measure the position tongue, the cup body mold should be the center,
• 2, put the board, about 5mm (big cup, if very small cup, about 3mm),
• 3, mold should be parallel (parallel with the mold hold frame),
• 4, mark the hole position (circle),
• 5, mark the center,
• 6, use 8.7mm diameter drill , drill depth around 30mm
• 7, Screw, M10 , screw depth around 20~25mm
• Marca: Check your machine, the bolt is what size (M10, M12, sau altele)

Schimb matriță de etanșare laterală a unui pahar de hârtie ZBJ-X12

manualul mașinii pahare de hârtie,how to change paper cup mold,cum se schimbă mucegaiul, change paper cup mold, schimbați întregul set de matriță pentru pahare de hârtie,schimbați matrița pentru a face diferite pahare de hârtie,cum să faci pahare de hârtie,how to run paper cup machine, paper cup machine maintenance